How to make a mantle.


Home(Japanese)	Home	Introduction	How to sewing.	Paper pattern download	How to Sewing video.

	1) Make a copy of paper pattern mark. Let's make notches for alignment before sewing it (You put an around 5-8mm cut in a margin for a seam so that the cut is not seen from the right side as to align the position of sleeve and sleeve cap as well.)
1) 2) 3)	2) Put the paper pattern on to the material and mark around it. On youhave done this cut along the lines. Fist rough cut material bigger than pattern. Also rough cut interfacing bigger than pattern and smaller than material and stick on the material with iron. front side. reverse side. facing material.
	3) That is a method of zig zag sewing for home use. Make edge of cloth comes to center of metal holder. When needle goes down on right side, As to be forced out and sew zig zag. This way a part that being forced out covering edge of cloth and not to get frayed.
	4) Put the bodice and facing together face to face. Sew the center front and hem.
	5) Turn the material inside out. Sew the center front 0.5cm in from the edge.
	6) Sew the both shoulders. Fold the margin towards back side.
	7) Put the material together face to face. Sew the center back to the end of the opening. Spread open the seam.
	8)
	9) How to squeeze gather. Make longer sew length on the machine.
	10) Turn down the dial for the upper thread.
	11) Start sewing from 1.5cm from the edge. Sew 2 lines in margin to sew up. Sew 2 lines gatherer better than 1 line.
	12) For beginning of sewing , make sure have extra thread after machined. For the end make sure have extra thread and cut.
	13) Made to original thread adjustment. Sew the hem.
	14) Sew the collar.
	15) Fold the one side of collar band 0.8cm in from edge.
	16)
	17) Put the upper collar together face to face. sew the red line.
	18) The blue and green lines are the same length in edge. Don't joint together at the tips. Put the face of the collar 2-3mm inward. Pin together at equal lengths from the center of the collar. The collar has become baggy. However, If you place pins equally, the collar will not become wrinkled. use the unpicking scissors then take up length.
?2 ?3	19) If you merely sew, when you will result in a bad collar. the collar edge is lifted and looks bad. Therefore, I put a collar of the topside of collar 2-3 millimeters.
	20) Turn the material inside out. Sew the collar 0.5cm in from edge.
	21)
	22) Turn the material inside out. Sew the red line.
	23)
	24) How to sew the hand sewing of video.
	25) Sew the button hole. Sew the button at opposite side.
Explanation on the pattern. Area that apply interfacing. Finishing line margin to sew up position where gather. position where cover with baiastape, where mark the pattern. adjusting position of sewing together. place cut already 5~7mm adjusting position of sewing together. make a hall on the conner. direction of material. layer this line will parallel with height of material. Where the corner, drawing a point the material as a mark.